indicators and bonnet front attachment

Made some progress today - got the indicators assembled (using self tappers rather than the rivets suggested in the manual) Drilled out the holes for the indicators on the nose cone, and did the very tricky job of drilling out large holes in the nose cone to fit grommets into which the pins that are now screwed into the bonnet slide, it seems to work OK, and does improve the 'shut' lines where the three panels meet at the front of the bonnet.




































Here is a complete list (we think) of what there is left...

fix fog light switch
Drill out dashboard
reversing light connection
Empty water system
Disconnect dashboard
Brake Lines - template?
Drill and fettle Rivnut holes for scuttle in body
Drill and fettle Rivnut holes for scuttle in scuttle
nose cone rivnut location and drilling
Bonnet Grommets and lugs
nose cone grill
front indicators mount
front indicators wire up
Bonnet Locks?
Fix top Body
Nail on lower body
speedo wire up
rear mud protectors
indicator repeaters
Bleed Brakes
Windscreen pillars and mirrors
Windscreen
Side screens? when?
Wiper wheel boxes
wiper motor
wiper motor rods
wipers
washer jet
demister pipes
interior panels
Scuttle wiring loom hole
Nail and stick scuttle down
VIN plate
spare wheel bracket
spare wheel retainer and fixing stud
number plate panel
number plate light
boot box bolts
front cycle wings
interior mirror
dashboard trim
top cover aluminium panels
gaiter for handbrake
gaiter for gearstick
carpets
crashpad
headlamps
sort out termination of throttle cable
fabricate retaining clips for dash